Search found 4 matches
- Thu Apr 25, 2013 8:56 pm
- Forum: EnvisaLink ( IP100D, IP170D, 2DS, 3, 4)
- Topic: PC1616/RFK5501 - KEYB LED not lit
- Replies: 6
- Views: 9586
Re: PC1616/RFK5501 - KEYB LED not lit
Done, thanks. Ticket #: 13007
- Wed Apr 24, 2013 2:47 pm
- Forum: EnvisaLink ( IP100D, IP170D, 2DS, 3, 4)
- Topic: PC1616/RFK5501 - KEYB LED not lit
- Replies: 6
- Views: 9586
Re: PC1616/RFK5501 - KEYB LED not lit
The multimeter measured the following:
~6.97V on yellow
~9.10V on green
Yellow matches what you said (~7) but green is a couple V higher. Does that indicate a problem or is it still within the expected operating range?
~6.97V on yellow
~9.10V on green
Yellow matches what you said (~7) but green is a couple V higher. Does that indicate a problem or is it still within the expected operating range?
- Tue Apr 23, 2013 8:05 pm
- Forum: EnvisaLink ( IP100D, IP170D, 2DS, 3, 4)
- Topic: PC1616/RFK5501 - KEYB LED not lit
- Replies: 6
- Views: 9586
Re: PC1616/RFK5501 - KEYB LED not lit
I tried a new wire, with the same results.
The local home page says "Security Subsystem - DSC" so I should be on the correct firmware.
I do not have a multimeter but I'll try to borrow or purchase one tomorrow and measure the voltage. Thanks for the suggestions...I'll keep you posted.
The local home page says "Security Subsystem - DSC" so I should be on the correct firmware.
I do not have a multimeter but I'll try to borrow or purchase one tomorrow and measure the voltage. Thanks for the suggestions...I'll keep you posted.
- Mon Apr 22, 2013 9:15 pm
- Forum: EnvisaLink ( IP100D, IP170D, 2DS, 3, 4)
- Topic: PC1616/RFK5501 - KEYB LED not lit
- Replies: 6
- Views: 9586
PC1616/RFK5501 - KEYB LED not lit
Hello, I am trying to install the envisalink3 on a PC1616 control panel with one RFK5501 keypad. All of the LEDs display correctly except for the KEYB. It comes on for about a second when I connect power to the panel then it goes off and stays off. Everything I've read indicates that this means the ...