EyezOn Forum

They are pretty standard. Here is the DigiKey part number from Richco. RPC1126-ND thanks. would these 10mm work? https://www.amazon.com/Support-Standoff-Isolation-Locking-Insulation/dp/B0BHZSBDD2?crid=1ZS5ABHZXKXNT&dib=eyJ2IjoiMSJ9.2qszlFAtYXcSY9_-DyP5c1G-VvPY8aSVQvOm ...

i've had the evl3 installed in my dsc1864 panel case for quite a few years now and it has worked fine...but only with the top two standoffs in place (so the board wobbles a bit when pushed on). recently i've added the alula bat connect, and it's driving me nuts that the board is in there flapping ...

would that not then mean the same thing is true for any monitoring though? or is there a question i can ask them concerning this?

right now i don't use the EVL for anything except integration with HA. i have an eyez-on account and occasionally look at it for self monitoring or running commands if HA is acting up on me, but other than that i don't do anything else with it. my current monitoring center said they can monitor the ...

i've got a DSC power series PC1864 that i have had installed for 10+ years now and has been working well the entire time. in an effort to cut costs, though, i'm looking at potentially dropping our home phone line since we finally seem to have decent enough cell service in the neighborhood to allow ...

i have a dsc power series pc1864 alarm panel in my home that was installed in 2013, along with an envisalink 3. i am using the evl3 strictly to connect the alarm to my home assistant install...for almost 8 years, this has worked perfectly. recently though, i've occasionally started seeing the ...

time zone is still off by an hour...just armed my system, events log says it was armed an hour later than actual. please advise...

OK that explains why my alerts are an hour ahead now, since it's set for EDT and it's now EST...but it didn't switch me over automatically (or something strange happened somewhere that switched me back). I set everything up while I was still in CA with the system, which was when daylight time was ...

i just disarmed my system remotely to allow plumbers to come in and do some work, which worked fine...however i noticed that the time alerts are off by an hour. i'm in PA (eastern time) and the system is in CA (pacific)...my account says that my time zone is EDT -400, which is correct for when i set ...