EyezOn Forum

Envisakit should be sticky and should be the core of all honeywell development: https://github.com/mklips0/envisakit Seems like this was probably the wrong topic. (There is another topic for Ademco, but this isn't really about documentation.) I think it would be helpful if there was a (sticky ...

I got TPI communication with my envisalink 4 (and vista20p) working with envisakit. It's opensource, very easy to install (just a python script) and works in windows and linux. I'm suprised this hasn't been mentioned in this topic. Thank you mklips0 for sharing the code. Envisakit should be sticky ...

Thank you GrandWizard! I entered the following command and it worked indeed (no more open/close reports):

*65 000
*66 000000

It's a bummer I can't split the reports to the dialer and the communicator.
Can anyone help me how to disable reporting on arm/disarm?
(reporting on alarm/emergency must ofcourse kept activated).

I believe it has to be done through *49 or *65.

Thank you for the reply GrandWizard. I think understand the issue. So my options I believe are: - disable reports for open/close events and enable phonecalls. This will avoid the phonecalls for each open/close action (and only receive calls for emergencies), but will also disable the email ...

I believe this issue should be in a seperate thread for future references. I have a vista20p with EVL4 and everytime when I arm/disarm then the monitoring central numbers are being dialed. I put my number there aswell (to get a phonecall incase of emergency. 8 calls if no handshake). This was an ...

Thank you all for the help. I installed it yesterday. The installation went fine (got 5 green leds in no time). I can now arm/disarm the system remotely and get email notifications (which is great)! But I have one big problem: Everytime when I arm/disarm then the monitoring central numbers are being ...

I got these sources on disconnecting the power: https://www.youtube.com/watch?v=XT_jJwtaf4I https://www.alarmgrid.com/faq/how-do-you-power-cycle-a-honeywell-vista-series-alarm-control-panel Both seem to verify that I need to first disconnect the main power (eg by disconnecting wire 1 or wire 2) and ...

Thank you again for your reply GrandWizard. And thanks for bearing with my newbie questions. I marked the terminal 1 wire in the picture below. So I assume this is the wire I have to remove... But what do I have to do to remove the battery? I also see the greenyellow/red/black wires on the marked ...

There are no pictures attached to your posting. 1. You will not lose your programming when you remove power. Settings are stored in non-volatile memory. 2. There are full pictures of the connections in the manual 3. Yes, that would be a typo 4. The foam rubber two-way tape give Honeywell users an ...