EyezOn Forum

You are right. Section 009 has 09 then 04 in it. According to manual this is smoke detector 2 wire. If I change this to 09 then 20 it should fix the zone fault? I just wanted to double check. I read the PGM section in the manual, it seems that should do it but there are a lot of other options as well

I just went through all the zones.
All the smoke detectors were already turned off (00). There are no 07/08 settings (smoke detectors).

Yet, the panel still shows Fire Zone Fault.
How can I fix it? I tried rebooting the panel, but no luck, error still shows at startup

Thank you! This worked. Is there a way to disable the smoke detectors completely? I have a Fire Zone fault on my DSC. All smoke detectors have been disconnected and replaced by battery ones. It seems that it might be something to do with zone 009, but I'm not not sure of the exact settings to just ...

Hello, I have a DSC 832 system that has been working great. I have 2 questions: - How do I disable remote monitoring? The keypad likes to tell me that I need to check the phone line. I do not have the phone line. I use an Envisalink. How can I remove this check? - How do I remove a keypad? I have 3 ...

One setup that is possible: - EnvisaLink - Raspberry π - Smartthings hub You can install the following: - Smartthings bridge for EnvisaLink <-> Smartthings ---- https://community.smartthings.com/t/dsc-evl-3-4-alarmserver-smartthings/ - HomeBridge plugin for Smartthings <-> HomeKit ----- https: ...

Hello, I have an alarm system that has labels for all zones (ex Front Door). On my envisalink, however it only shows "Zone 1" without the nice labels. Is there any way to know what which zone is without going through opening all the doors and writing things down on a piece of paper? I was playing ...

Hello,

when I type the local IP address of my Envisalink in a browser, I get a message "It works". Nothing else.

How can I get rid of this and access the configuration page?

Hello, I just bought: - Envisalink 4 - Raspberry pi - SmartThings hub 2.0 I'd love to integrate them all together. I read AlarmServer would do a great job but after looking for a few hours cannot find a tutorial for it. Has anyone done something similar? What were the steps? The closest I found was ...

Hello,

I am about to buy the Envisalink 4 to link with my DSC alarm.

The EVL4 CG version is cheaper than the EZR version.

Is it ok if I go with the CG? not sure what the difference is but I'll be installing it myself