EyezOn Forum

EVL4 FEATURE REQUEST: Full 4-octet IP address for syslog It's not necessarilylikely that the syslog server lives on the same subnet as the EVL4. This seems trivial to add. I've resorted to using NAT trickery to get around this limitation. This has been asked for in the past and Envisacor says no ...

how about two octet on ip address.

what is the change log on sw version 164

My hardwired doors are not updating to closed, various window are open as it is 78 out! Honeywell alarm pads update properly. Can I get my firmware downgraded to the last stable version.

toddaustin wrote:Cool feature! But can I make a request to please allow more customization of the server IP address. My server is sitting on 192.168.2.xxx, but your config screen assumes it must be on 192.168.1.xxx

I really wish they would fix this as well.

https://community.smartthings.com/t/release-honeywell-ademco-vista-20p-integration/41227 Native SmartThings support. I have 40+ sensors which would be great to have the sensors feed SmartThings. I bought the evl4 knowing that it doesn’t have native support, but am using redloro’s nvm node.js server ...

Did you enable shadowing?
I’ve got a vista-128 and honeywell communicator (G4 and Ethernet) and it works.

When setting static IP address, please allow me to change the whole address and not just the last number. Or at least the third and fourth number. My network is 192.168.0.1 with a net ask of 255.255.240.0, which is a large network:) . I set the dhcp server to start at 192.168.1.1 and up reserving ...

@andrep What you are using is 'supernetting'. That is using a network range bigger than the network class in this case a Class C would normally allow. This is perfectly legal from a networking point of view but perhaps less command and sadly some networking equipment and software does not always ...

I got EVL V4 working on Honeywell Vista-128BPT alarm panel. Main purpose was to get SmartThings integration. I have remote access thru Honeywell TC, with a network/cellular communicator.

Would like to see native support for SmartThings.

https://community.smartthings.com/t/release-honeywell-ademco-vista-20p-integration/41227 Native SmartThings support. I have 40+ sensors which would be great to have the sensors feed SmartThings. I bought the evl4 knowing that it doesn’t have native support, but am using redloro’s nvm node.js server t ...