EyezOn Forum

One additional comment - it takes a few minutes before the notifications start to work. Be patient (I wasn't).

Would it be possible some details for app notification categories (at least that is what they are called in Android)? Specifically, I would like information on which categories are alarm categories (and therefore bypassing 'do not disturb') and which are not and a mapping of the category names to ...

For the record, zone type 8 is the best. It alerts the panel and sends an eyezon 'non-alarm' alert. Perfect for dealing with it at your leisure, rather than waking you up at night.

Zone type 12 is good for things like flood sensors - alarm to Eyezon so it gets through do not disturb.

Today (Feb 22/24) I am not receiving push notification in the Android Eyezon app. It maybe coincidence, but I did get a new phone a week ago. However, the push notifications on not coming on my old phone either which has had no changes. Is there a problem on the back end? I have uninstalled the app ...

Apparently Google/Samsung have changed things with OneUI5/Android 13 regarding how do not disturb works. I used to be able to set do not disturb by message category, but that has disappeared. I want to make sure that I don't miss important Eyezon notifications, while letting less important ...

I am switching to a new phone. I had my old phone app customized for the types of notifications that should be sent. I expected when I would go to the contacts, that I would see my new phone there as a contact and then I could customize it. It is not showing up there. Do I need to do something for ...

I have a wireless horn (5800WAVE) connected to my Vista 20p panel. Occasionally, it loses network connectivity and I would like this reported to me, but not as an alarm condition (I have it setup as zone type 12 (monitor zone)). I would like conditions like this to be reported as "system trouble" or ...

I am doing a fresh install of the Envisalink 4 on a Vista 20p. All alerts are working properly from Eyezon, however, when I go to the device status on either the web page or the app (google) and it shows recent activity, it is showing activity on zones that I have not used and is currently marked as ...

In the TPI documentation it says that the envisalink board can only accept one tcp connection. If I have the board setup and connected to eyezon.com can I then have a local connection as well to the board and use the TPI to get data and interact with the board or do I have to terminate my connection ...

From what I understand, using the TPI is communicating directly the the Envisalink board and not the Eyezon.com web site. Is this correct? I am going to be communicating over a metered network, so I want to minimize the traffic to the Envisalink board. I was thinking that the board is pushing data ...