EyezOn Forum

So....i figured it out! When I hooked up the Envisalink4 the 107 issues started with my 4219 zone expander. Appearently thats when I also hooked up my 2nd keypad, it was a 6151 (6150 + 1 wired zone) and it by default uses the address 7 - same as my 4219! After installing a new 4219 and getting no wh...

So after installing the envisalink4 and making the programming changes to suit, it started working and my zone expander stopped working = 107.
Didn't find anything after checking everything... I bought a new 4219 and same thing 107!!!
Its killing me!

I will totally check that when I can.
Not sure where, but i found this tech sheet online. It mentions checking *25 = 1 if using a 4219 zone expander, but i cant check *25!?
It shows voltage readings closer to what i metered as well...
I'll try to attach it.

No auxiliary power supply installed. I metered BLK-RED: 13.4VDC I metered BLK-YELLOW: 11-12.9VDC I metered BLK-GRN: 0.200VDC(fluctuating a bit) Do you have an auxiliary power supplied installed on your panel? Measuring at the terminals of the expander, what is the DC voltage between BLACK and YELLOW...

Is there any specific programming errors that you can think of that would lead to zone expander error? As I have exhausted the wiring checks at either end. I had gone from still seeing everything on my V15P after envisalink installation, but having an error with the envisalink that programming wasn'...

Was there a resolve to this issue?
I have a V15 and Envisalink4 with the same issue with my zone expander...