Search found 4 matches

by rjtceaLz
Tue Oct 29, 2024 7:22 pm
Forum: EnvisaLink ( IP100D, IP170D, 2DS, 3, 4)
Topic: Help on Programming Honeywell Panel for EVL4 With Existing Monitored Service In Place
Replies: 7
Views: 886

Re: Help on Programming Honeywell Panel for EVL4 With Existing Monitored Service In Place

The Envisalink is actually two devices in one. It is both a keypad, and an external communicator. While the keypad function will still work if you have the onboard communicator enabled, the communicator portion will not work as the panel will not send any events to the ECP communcicator if the ...
by rjtceaLz
Thu Oct 24, 2024 2:28 pm
Forum: EnvisaLink ( IP100D, IP170D, 2DS, 3, 4)
Topic: Help on Programming Honeywell Panel for EVL4 With Existing Monitored Service In Place
Replies: 7
Views: 886

Re: Help on Programming Honeywell Panel for EVL4 With Existing Monitored Service In Place

No programming is lost, but you can't use the onboard Ethernet on the 21IP and the Envisalink at the same time. If you were using the external ECP Honeywell IP communicator for TC, then you could use shadowing, but the 21IP is different in that it want allow and external comminicator and the ...
by rjtceaLz
Tue Oct 22, 2024 5:46 pm
Forum: EnvisaLink ( IP100D, IP170D, 2DS, 3, 4)
Topic: Help on Programming Honeywell Panel for EVL4 With Existing Monitored Service In Place
Replies: 7
Views: 886

Re: Help on Programming Honeywell Panel for EVL4 With Existing Monitored Service In Place

Thanks for the reply. My follow up question is if I then disconnect the ethernet cable from Envisalink will TC resume and vice versa OR in configuring for Envizalink does it wipe out the TC programming ? My original understanding was that both could co-exist based on another post I subsequently saw ...
by rjtceaLz
Sun Oct 20, 2024 1:52 pm
Forum: EnvisaLink ( IP100D, IP170D, 2DS, 3, 4)
Topic: Help on Programming Honeywell Panel for EVL4 With Existing Monitored Service In Place
Replies: 7
Views: 886

Help on Programming Honeywell Panel for EVL4 With Existing Monitored Service In Place

All I know there is the link to the Honeywell Programming (https://www.eyez-on.com/EZMAIN/EyezonEnvisalinkHoneywellInstallationGuide2018.pdf#page9) but I had a question before I start doing this with an EVL4. Specifically, already have totaljconnect / alarmnet monitoring on the panel. Can I just ...