EyezOn Forum

ah, very helpful. thanks

I've replaced an old DSC with an UNO board and everything works, which is great. One thing I had to do was turn off the need to have pull-up resistors on each zone as my old system didn't have them. My question is whether there is any benefit to adding a pull-up resistor to each zone? If not, why is ...

ah, ok, I understand. Another option is to put the non security (water, temp, fire) zones on the expansion board and mount it to the wall next to the enclosure. Right now my main issue is there isn't a lot of room for a second enclosure without rearranging a bunch of other stuff on the wall ...

I just replaced my DSC 5015 with a UNO board and it fit perfectly where the old board did in my enclosure. I've ordered the expander board but I just realized it won't fit in my enclosure as it also had a backup battery in it. The enclosure is 12"x11". I tried to look for a replacement enclosure ...

Thanks for this. I think I'll use this as a time to move to UNO. That will allow me to add wireless sensors in our garage.

Do you know if it will fit in the existing 5015 case or should I order one to match?

Athir

I saw there is an installer option to turn of the phone interface (015 option 7) but I don't have the installer code. I could reset the board but then I've have to program it from scratch. I'm hoping I can enable the ip monitoring and it will ignore that the phone line is down.

After a recent ice storm, my DSC system (with an EVL3) started reporting the following event "Phone Number 1 FTC". There was an issue with Bell but even after they fixed the line, the DSC still reported the line down. I think during the storm, the phone line interface on the DSC got zapped. So it ...