EyezOn Forum

I figured out why I wasn't getting alarms. I had set the report code to 00. Changed it to 10 and it appears to be working fine.

I'm having the exact same issue. The only difference is I'm using a 21iP panel. Please post solution if/when you figure it out and I will also do the same. Thanks.

Thank you for all your assistance. Looks like I still need a little more... I have *50 set to 15 seconds. I arm the alarm, wait 5 mins, set off a motion sensor, the panel indicates an alarm and zone number, wait a minute, disarm the alarm and never get a notification. I do get the opening and ...

Is that the way an alarm is reported? I guess I expected different verbiage. I have the check box for arm and disarm selected. Shouldn't I receive notification when I arm and disarm the alarm? Actually I think I'm receiving these messages when I arm and disarm the panel.... and no indicator when an ...

Thank you. The jumper was the key and not mentioned on the EVL3 configuration page for Honeywell. I am now getting two messages when I set the away alarm, trip it and disarm it. The first is: Security Event: Closing By User Code 2, Location: Home, Time: 2013-01-13 09:57:17, Partition: 1 and the ...

I am having difficulty receiving any messages/alerts. Web GUI connects fine and I am able to arm/disarm without issue. I have reviewed the Honeywell Configuration sheet without any success. I am not currently using the phone or internet connection on the 21iP board and do not have a GSM module ...