I have two keypads. After the install one is "frozen" and will not function. It has power and displays the message "Keypad Addr. 17 190"
(Pic attached).
Any help appreciated.
- 004.JPG (624.87 KiB) Viewed 3936 times
Honeywell Keypad Frozen after EVL-4 Install
Moderators: EyezOnRich, GrandWizard
Honeywell Keypad Frozen after EVL-4 Install
I installed an Envisalink 4 module a couple of days ago. Installation went well and everything is working well with the following exception.
I have two keypads. After the install one is "frozen" and will not function. It has power and displays the message "Keypad Addr. 17 190"
(Pic attached).
Any help appreciated.
I have two keypads. After the install one is "frozen" and will not function. It has power and displays the message "Keypad Addr. 17 190"
(Pic attached).
Any help appreciated.
Re: Honeywell Keypad Frozen after EVL-4 Install
Still need help with this please...
I tried "rebooting" the system by disconnecting the power and battery. After restarting the system, the keypad display is now blank,
but the keypad display lights are on. If I enter 1-3 simultaneously I get a display showing CON ADDR 17.
Note: The address on the keypad was not changed during install.
Any help appreciated.
I tried "rebooting" the system by disconnecting the power and battery. After restarting the system, the keypad display is now blank,
but the keypad display lights are on. If I enter 1-3 simultaneously I get a display showing CON ADDR 17.
Note: The address on the keypad was not changed during install.
Any help appreciated.
-
GrandWizard
- Posts: 2354
- Joined: Tue Nov 16, 2010 4:08 pm
Re: Honeywell Keypad Frozen after EVL-4 Install
Submit a tech support request from your Eyezon portal. We will be able to assist you better if we have your account info. I suspect you accidentally removed the green wire for this keypad during installation.