using DSC with EVL only

Information and support for EnvisaLink modules.

Moderators: EyezOnRich, GrandWizard

Post Reply
Zonker
Posts: 32
Joined: Tue Jun 18, 2013 12:57 pm

using DSC with EVL only

Post by Zonker »

Once fully programmed, is it possible to remove the DSC Keypad and only use the EVL Interface? Wireless devices would be handled by the RF5132 module. I'm pretty sure the keypad is set up in supervisory mode and if removed, would cause an error as currently programmed.

Thanks,
Top
Post Reply

Return to “EnvisaLink ( IP100D, IP170D, 2DS, 3, 4)”