Honeywell Vista 20P - Envisalink4 - FC Error

[GarretS]

Hi there, I just installed the Envisalink4 module and went through all the programming commands but I am getting an FC error displayed on the keypad.
The panel was previously monitored over the telephone line which I have since disconnected

The keypad functions normally, I can set\disable the alarm without a problem, keypad shows ready state but flashes FC
I've configured the app on my phone, it seem to function without a problem as well, I can set\disable the alarm, I can see the zone sensors as they get triggered in real-time, don't see the FC message on the app. Aside from the FC error on the keypad display everything seems to be working I'm just wondering if the panel is still trying to check-in over the line that is disconnected and that's why I'm seeing the error? can that be turned off since it's no longer monitored? which programming code did I miss?

Thanks

[Chicodog]

GarretS: I found this through a search. May be helpful to you:

https://www.alarmgrid.com/faq/how-do-i- ... well-alarm

Sounds like it walks you through removing the old phone number.

Hope this helps!

[GarretS]

Sorry for the late reply, that did seem to do the trick! No longer seeing the FC flashing on the panel
Thank you so much