Envisalink TPI Status missing

[radlebb]

I have an Envisalink 4 running with a DSC alarm.

I don't have the "Envisalink TPI Status" section under Network when I check the web interface.

I am however connected to it via DSCServer mobile app, though it's dropping out a bit so I'm wanting to check the Client IP.

I have:
- Network Parameters
- EnvisAlerts Status
- Syslog Client
- EnvisAlarm Status

and a reboot link at the bottom with "Firmware Version: 01.03.173" below that.

Any idea why it would be missing entirely?

[GrandWizard]

I don't recall in what version but they removed that a couple of years ago. The reason was to conserve code space for new features.

[radlebb]

Bummer. Any other way to see what IP the EVL4 is currently connected to?

Maybe there's a telnet or SSH interface?

[GrandWizard]

No, even in our support dashboard we can't see that info.

Do you have more than one device trying to connect?

[radlebb]

Well I thought I may have had an old one still configured (I have a lot of devices) so was trying to track it down.

If there's not way to do it then I'm out of luck.