User authority glitch

Information and support for EnvisaLink modules.

Moderators: EyezOnRich, GrandWizard

Post Reply
f0n7pgdgbf48
Posts: 6
Joined: Thu Aug 05, 2021 8:16 pm

User authority glitch

Post by f0n7pgdgbf48 »

This may not be a problem with the Envisalink per se, but any suggestions are welcome. After setting up my Envisalink, I initially created two extra users on my 6150 keypad. No problem. Now, I created a third user. I get a confirmation beep, but if I try to arm or disarm using the new code nothing happens. I've tried setting the user authority to 0, and again I get a confirmation beep but it has no effect. Any ideas?

Jeff
Post Reply