Motion events from SOME sensors not being logged

Information and support for EnvisaLink modules.

Moderators: EyezOnRich, GrandWizard

Post Reply
Jbintegration07
Posts: 1
Joined: Thu Jan 27, 2022 3:49 pm

Motion events from SOME sensors not being logged

Post by Jbintegration07 »

Hi - I have a few different motion sense zones in system. One of them, Zone 2 happily reports motion every time there is any in the eyezon interface. For the other two, the motion sensors “work” (red light turns on) but there isn’t any corresponding notification in the eyezon status monitor interface.

- Zone 2 - Kitchen (IS52535), zone type 4, report code 20
- Zone 6 - Garage (IS2500LT), zone type 2, report code 60
- Zone 24 - Remote room motion, zone type 2 report code 80

This is a single partition setup, all on partition 1.

I’m definitely a security system novice but an avid do-it-myselfer who loves the eyezon system…. I suspect there may be some flag in the alarm panel setup that has the other two motion sensors quiet? Or some sort of report code adjustment i need to make?

The panel is a Vista 128BPT.
GrandWizard
Posts: 2263
Joined: Tue Nov 16, 2010 4:08 pm

Re: Motion events from SOME sensors not being logged

Post by GrandWizard »

Does your keypad say FAULT ZONE 6? If not, then the Envisalink won't know about it either.

Honeywell systems report the status of open zones sequentially when multiple zones are open, lowest to highest. Because motion zones are only open for a second, the panel sometimes never gets around to notifying the keypads that they are open before they are "closed".

DSC panels do not suffer from the limitation.
Post Reply