Partition Creation - DSC PC1864 and Envisalink 3

[indring@gmail.com]

Hi, been wanting to try creating partitions for some time now and finally got around to it. I created 3x partitions, Partition 1 - All Exterior and Interior Beams/ PIR's, Partition 2 - Exterior Beams only and Partition 3 for Interior PIR's.

As for as I can see, I've enabled the partitions under section [201] and the individual zones are selected under the partition zone assignment [202] to [221], done as follows:

partition zones.jpeg (183.99 KiB) Viewed 7547 times

The issue I have for Partition 2 (Exterior) & 3 (Interior) is that it does not show the zones and something I picked up is that even if a zone is opened, I can still activate arming in Partition 1(Exterior & Interior). For now I've just disabled Partition 2 & 3, until I can get some help to figure out what I've missed?....

envisalink partitions.jpeg (168.74 KiB) Viewed 7547 times

[jon]

In case anyone else runs into this thinking their partitions are not getting detected by Envisalink, just be sure to log in to the web portal and name your devices + assign them to the correct zone (Manage Device -> Zone Labels). You should see them in the correct place in the mobile app afterwards.