Uno Hybrid Security System

[dv8]

I purchased an UNO hybrid IP with an UNO5500RF keypad. I am attempting to add an Ecolink WST-600 RF sensor however I cannot find the documentation to do this.

I have configured the keypad RF format to be DSC under #3 settings. I tried to follow DSC documentation for adding an RF sensor but it does not work. I also tried manually adding a zone in the app with both UNO-RF433 and DSC RF Receiver zones types but neither seemed to work.

Any suggestions or advice on how to add an RF sensor with the UNO5500RF?

Also, I do not see any carbon monoxide zone definitions. Should I use one of the fire zone definitions for carbon monoxide?

TIA!

Edit: Some more details on my very basic initial system config. I have the following hooked up:

1. UNO5500RF
2. Backup battery
3. Bell
4. DSC LC-100PI motion (Zone 1 - wired, entry/exit)
5. Magnetic door sensor (Zone 8 - wired, interior)
6. Sidekick LTE module

[dv8]

I purchased an UNO hybrid IP with an UNO5500RF keypad. I am attempting to add an Ecolink WST-600 RF sensor however I cannot find the documentation to do this.

I have configured the keypad RF format to be DSC under #3 settings. I tried to follow DSC documentation for adding an RF sensor but it does not work. I also tried manually adding a zone in the app with both UNO-RF433 and DSC RF Receiver zones types but neither seemed to work.

Any suggestions or advice on how to add an RF sensor with the UNO5500RF?

Also, I do not see any carbon monoxide zone definitions. Should I use one of the fire zone definitions for carbon monoxide?

TIA!

Edit: Some more details on my very basic initial system config. I have the following hooked up:

1. UNO5500RF
2. Backup battery
3. Bell
4. DSC LC-100PI motion (Zone 1 - wired, entry/exit)
5. Magnetic door sensor (Zone 8 - wired, interior)
6. Sidekick LTE module

Interesting and unexpected update. I removed the cover from the Ecolink and the alarm system triggered. I guess it was connected and now I can see the sensor listed in "RF Signal Strength" settings.

Ultimately, using the UNO-RF433 zone type seems to have worked.

What zone type do I used for CO?

[GrandWizard]

Use INSTANT FIRE

[dv8]

Use INSTANT FIRE

Thank you.