Arming stay remotely

[Liquidskies]

Hi Everyone,

Sorry, this may be a silly question but I haven't managed to figure out how to arm my panel in stay mode remotely through the webinterface on my iPhone. I have DSC power-series 1864 alarm.

Thanks
Simon

[PurdueGuy]

Are you able to arm remotely at all?

When I bring up the mobile interface, I get a device list, with only 1 entry for me, named "Home"
So I do the following:
Home -> Arm -> scroll down to "Arm Stay" and select it. A few seconds later, my panel is in "Entry/Exit Delay" and then "Arm Stay"

What do you see? Or what does your panel do? If you arm via "*0" and violate an entry/exit zone, what happens?

If it arms in "Away" mode anyway, make sure you have some zones marked as "Interior Stay/Away (05)" or the like, otherwise the system will default to "Away" mode, since "Stay" mode doesn't make sense if you don't have interior sensors setup for delays.

[Liquidskies]

Hi,

Thank you for the quick response. I have a strange situation that I sometime need to arm the house with the dogs inside my house, so I need to arm in stay mode. I only have the option to arm away. I have included a screen shot. I am able to bypass open zones. If I select the settings icon next to arm a new screen pops up with the title Commands for Zone 1 - I then have a section beneath it called Programmable Outputs (PGM) and a field which I can type in labeled PGM# then a toggle button beneath that. I have another section below that with the same layout labelled Zone Bypass, then a custom Sequence section, a Miscellaneous section where I can reset, reboot and cancel.

Would I need to put in some custom code to arm away, would there be no way to toggle between stay and away?

Thanks for your help.
Simon

[PurdueGuy]

Don't click the icon next to "Arm" instead click "Arm" itself. You should get the following (the are the same page, the second is just a little further down the page).

[Liquidskies]

Thank you so much for the help. It is much appreciated.