Can't get commnd 032 to work through TPI

[rustyk]

I'm using the Envisalink 3 TPI to control my DSC PowerSeries system. I can successfully arm the system using either command 0301 (arm-away partition 1), or 0311 (arm-stay partition 1).

However when I try to use command 0321 (zero entry delay arm partition 1), it does not arm the system at all.

I do get the command acknowledgement 500032 back from the TPI, so I know the command goes through, but then nothing else. When I try it, the keyboard on my DSC system says "Programming" on the display for about 15 seconds or so, then goes back to not-armed. I am able to put the system into zero entry delay using the keypad, so I know the DSC can do it.

My Envisalink 3 firmware version is 01.09.111.

Something I'm missing? Any advice is appreciated, thanks!

[rustyk]

Could anybody else verify that this command does or does not work for them?

[GrandWizard]

I'm not an expert here but do you have to enter a user code to enter zero-entry delay on the keypad?

[joako]

If you can post your full command with the checksum I can test it on my system, e.g.: 02011F4 for activate PGM 1 on partition 1

[Stavros]

Hi Rusty,

I can confirm that this does not work. I am on version 01.09.111 of the firmware.

When I attempt to use this command I receive a response of 680 which is the installers mode command response.

Did you have any luck getting it to work?

Would any of the EYEZ-ON guys be able to comment on this?

Cheers

[K-Man]

Sorry, we don't monitor this forum very often.

It looks like there is a bug here. What's happening is you are getting a 680 command when you should be getting a 900.

It will be fixed in the next release.

Kieran
Envisacor Technologies

[K-Man]

This firmware is in final QA. It should be released this week.