Hi,
I bought a IP100D 2 months ago and connected to my PowerSeries 4 Zone control panel PC585.
Its been working fine this last 2 months, I receive emails within 10 seconds after I arm/disarm the alarm.
My alarm actually is also using my phone line to call the company that installed the alarm system for me and monitors it (I pay a monthly fee). I would like my alarm system to stop using my phone line and only send me emails when I arm/disarm the system. I could disconnect the phone line but it will give an error in the panel and I dont want that.
How can I do this?
Please advice,
Thank you,
Regards,
RMRG
Disconnect call from PC585
Moderators: EyezOnRich, GrandWizard
-
- Posts: 134
- Joined: Wed Nov 17, 2010 11:53 am
Re: Disconnect call from PC585
You need to have access to installer's programming to change that. If you do then it is very easy. If not you'll have to contact the company that put in the panel and/or is doing the monitoring.
Re: Disconnect call from PC585
Hi,
I have the master code and a KeyPad to program the alarm. Is there a sequence of codes that I can input in order to do that?
Please advice.
Thank you,
Regards,
RMRG
I have the master code and a KeyPad to program the alarm. Is there a sequence of codes that I can input in order to do that?
Please advice.
Thank you,
Regards,
RMRG
Re: Disconnect call from PC585
It's good you have the master code, but you will also need the installer code to access programming.
You will need to disable telephone line monitor and disable the communicator.
You will need to disable telephone line monitor and disable the communicator.