LngRngRadio check 103 0005 after install on Honeywell 20p

[bugmann78]

I am having trouble using both my GSM and the evl-3. I receive alerts on my phone and can arm system remotely. Alarm company keeps calling saying they are not receiving signal back from GSM.
I have EVL-3 disconnected currently until I can fix issue.

I have the shadowing box checked.


Any suggestions?

[GrandWizard]

If you have "shadowing" enabled, the Envisalink becomes completely invisable to the Vista. There can be no conflicts, at least from a bus point-of-view. Get your GSM module up and running without errors and then add the Envisalink.

[bugmann78]

I had no issues with GSM prior to install. I will wait a few days to see if I get any errors without EVL-3. Could mobile link cause errors. Seems like after I installed my copied link to wife's phone problems started.

Radio alarm would appear after remote arm then disarm from mobile link.

I have a older Honeywell with rev 7.

[GrandWizard]

It is more likely that some changes in programming (panel) has caused the problem. Did you make any changes to panel programming during installation of the Envisalink?

[bugmann78]

Set keypad to 20

*48=77
*49=5
*50=2,0
*54=0
*55=1

All these to 1,1
*59 - Exit Error Reporting
*60 - Trouble Reporting
*61 - Bypass Reporting
*62 - AC Loss Reporting
*63 - Low Battery Reporting
*65 - Openings (disarming) Report
*66 - Closings (arming) Report
*67 - RF Low Battery Reporting
*68 - Cancel (opening after alarm) Reporting
*70 - Alarm Restorals Reporting
*71 - Trouble Restorals Reporting
*72 - Bypass Restorals Reporting
*73 - AC Fail Restoral Reporting
*74 - Low-Bat Restoral Reporting
*75 - RF Low-Bat Restoral Reporting