Vista 20p setting up second partition

[mitsu2k]

I have a vista20p system and just added a zone in partition 2. My question is, how do I setup this zone on the web portal? All I see is partition 1 and no option to setup partition 2. Even when I go to label zones all I have is "1" listed in the available partitions. Would greatly appreciate some help on this. Thanks!!

I'm using the EVL3 module

[dcuste]

After logging into the Web portal, select "manage device" in the upper right of the screen. Then select "zone lables". This will bring you to a place to enter each zone number , lable, comments and there is a drop down to select the partition for each zone. Then select update and you're done.

[mitsu2k]

Yes thank you for the reply. When I do as you said the only option I have is partition 1. 2 is not listed at all. I might want to mention by the way that I only have one keypad on my system. Could this be the reason?

[mitsu2k]

Ok I figured it out. Basically I had to go to the local config page and enable the partition 2 keypad address (17 in my case). Then partition 2 became an option on the web portal.