Comm Failure Help?

[mrtripp]

Ok so i got an ademco Vista 20p with 1 6160 keypad, 1 6160rf keypad and 5 wireless sensors and the envisalink 3 all is working, can arm disarm and i am getting all reports the only problem is i am getting comm failure displayed on the keypads. I am self monitoring as of this moment and was going to sign up with eyez-on for monitoring through the evl 3. How can i get it to stop reporting a comm failure as i am not using telephone lines its all ip through the evl-3.

Thank You In Advance,
Jeff

[Flyct]

If you have anything in the phone number entries in programming you will get comm Failures after the board tries to dial and cannot connect to central station.

You should delete entries in *41 through *46

After entering programming type *41* *42* *43* *44* *45* *46* *99

[mrtripp]

If you have anything in the phone number entries in programming you will get comm Failures after the board tries to dial and cannot connect to central station.

You should delete entries in *41 through *46

After entering programming type *41* *42* *43* *44* *45* *46* *99

Thank You Flyct That solution has resolved my problem!

[Flyct]

^^^^^^^ Glad that worked for you