Do I need to disable the phone line health monitoring?

[Calum]

My DSC5010 has two trouble codes dealing with the phone line. Trouble code 3 is for the actual phone line, I'm assuming it monitors the line voltage to ensure there is a phone line connected. Trouble code 4 is for the actual end to end communication, I'm assuming the monitoring station transmits a signal to indicate it received the panels transmission correctly, or something to the effect.

Do I need to disable these when I disconnect my phone line monitoring?

Thanks for any help

[GrandWizard]

Yes, you should disable TLM and remove the phone number from the primary dialer. Otherwise you will get these troubles on any panel event.

[Calum]

Thanks. I wasn't sure if that would be part of the setup or not. At $49, I was kind of expecting that much reprogramming to be included. I have the installer code, manual and program sheets though, so I'm sure I'll be able to figure it out.