Updating time

[Calum]

Is there any way to cause the time to be updated? After installing my Envisalink 3 yesterday my time was off by two hours. I went to the website, corrected the time zone setting hoping my panels would be updated, but they haven't been. Any suggestions? Can I still set the time manually?

[GrandWizard]

DSC systems have the option for auto-time updates. This will update your panel's time to network time once a day, usually around 03:00 local time. You must make sure your timezone setting is correct in your Eyezon account and also make sure your panel is not programmed for auto-DST as the server will take care of this for you.

[Calum]

Thanks GrandWizard. The time zone is set correctly in my Eyezon account.

I have a DSC 5010 version 2. I been through the Programming worksheets, the installation manual, and the instruction manual. There is no mention of a daylight savings time option. Version 3 and up of the DSC 5010 has the option in section 017 option 6. I tried entering the programming sequence for section 017, but all I get is a long beep telling me that section doesn't exist.

But, here's the kicker. The time has been following DST without intervention from me. So, I'd say the DST option is what is causing my issue, but I can't figure out how to turn it off.

You wouldn't have any further tricks up your sleeve would you?