Honeywell 250P1 With EVL-4CG

[chspyder]

I have tried all the manuals and none of the programming codes match with my alarm, any ideas are greatly appreciated!

Honeywell (ADEMCO) 250P1
With EVL-4CG

Error: Keypad Address Programming Not Completed. See Part 2.1 in the Programming Guide
Error:*29 Programming on panel not completed properly. Programming Guide

Thanks
CHS

[chspyder]

The system is a 250P1 aka Vista 10P I am able to program all but the step 2. Keypad programming it will not accept *190 to *196 . help anyone?

I sometimes get both errors but usually now I only get
Error: Keypad Address Programming Not Completed. See Part 2.1 in the Programming Guide

[GrandWizard]

No, that is closer to a Vista 10SE not a 10P. It is too old and not compatible with the Envisalink.

Sorry