Re-Configure

[DeanRobinson]

If I purchase a EnvisaLink4 and configure it for a DSC panel "hook it up for a few months" then take it out of the DSC panel and default the Envisalink4 to factory settings, can I then put it in a Honeywell panel and reconfigure it to work with the Honeywell panel?

Thanks!
Dean

[GrandWizard]

Yes, the Envisalink will just download whatever firmware is required for your panel.

[DeanRobinson]

OK Great! I was hoping you would say that, I have installed quite a few of these boards in Vista panels, But never in a DSC, If I understand this correctly there is no programming need on the DSC's
The DSC panel is about 15 years old is the board compatible with a system that old?


Thanks!
Dean

[GrandWizard]

You will find the installation much easier with DSC systems. The Envisalink works with all vintages of POWER series panels going back to the PC5010, about 20 years ago.

[DeanRobinson]

I checked the panel today, It's a Power 832 / PC5010 I assume that the envisalink should work just fine, I also assume I don't have to get into the panel and make any changes at all to make it work?

Thanks for the replies GrandWizzard!
Dean

[DeanRobinson]

GrandWizard I assume to default it so I can install it on a Honeywell Vista system I just jump the 2 gold pads with the power on then reboot and then configure it as a Honeywell?

I got it up and running on the DSC system last night so all is working well on the DSC system.

Thanks!
Dean