Honeywell Setup Improvement Suggestion

[jlatham]

So, as a suggestion for improvement, the Quick Start Manual for the EnvisaLink 3 has the first step to be Connect the Module to the Control Panel. The second thing, Panel Programming, which points you to a website if you have a Honeywell.

On this website, it states that it's very important to Activate the Module first and THEN connect to the panel, which most users have probably already done. This is just asking for problems... as a suggestion, maybe state at the very beginning that the print guide is for DSC users only and just point Honeywell users to the website that has full instructions. Just a thought.

[GrandWizard]

These are all very good points.

Thanks for the feedback, we will improve the instruction for Honeywell users.