EyezOn Forum

I am having trouble using both my GSM and the evl-3. I receive alerts on my phone and can arm system remotely. Alarm company keeps calling saying they are not receiving signal back from GSM.
I have EVL-3 disconnected currently until I can fix issue.

I have the shadowing box checked.


Any suggestions?

If you have "shadowing" enabled, the Envisalink becomes completely invisable to the Vista. There can be no conflicts, at least from a bus point-of-view. Get your GSM module up and running without errors and then add the Envisalink.

I had no issues with GSM prior to install. I will wait a few days to see if I get any errors without EVL-3. Could mobile link cause errors. Seems like after I installed my copied link to wife's phone problems started.

Radio alarm would appear after remote arm then disarm from mobile link.

I have a older Honeywell with rev 7.

It is more likely that some changes in programming (panel) has caused the problem. Did you make any changes to panel programming during installation of the Envisalink?

Set keypad to 20

*48=77
*49=5
*50=2,0
*54=0
*55=1

All these to 1,1
*59 - Exit Error Reporting
*60 - Trouble Reporting
*61 - Bypass Reporting
*62 - AC Loss Reporting
*63 - Low Battery Reporting
*65 - Openings (disarming) Report
*66 - Closings (arming) Report
*67 - RF Low Battery Reporting
*68 - Cancel (opening after alarm) Reporting
*70 - Alarm Restorals Reporting
*71 - Trouble Restorals Reporting
*72 - Bypass Restorals Reporting
*73 - AC Fail Restoral Reporting
*74 - Low-Bat Restoral Reporting
*75 - RF Low-Bat Restoral Reporting