Page 1 of 1
Mounting kit for EVL 3 module
Posted: Wed Jun 11, 2014 10:52 pm
by Waynech
I have to mount the EVL 3 module at the end of the DSC keybus to get access to an eithernet cable. Module works fine. Do you have a mounting case for the module so that I can protect and secure the module?
Re: Mounting kit for EVL 3 module
Posted: Sat Jun 21, 2014 7:15 pm
by hokie21
I used double sided foam tape. It works ok. It would be nice if EyezOn provided a convenient and secure alternative.
Re: Mounting kit for EVL 3 module
Posted: Sun Jun 22, 2014 9:06 am
by DaveSin
Waynech wrote:I have to mount the EVL 3 module at the end of the DSC keybus to get access to an eithernet cable. Module works fine. Do you have a mounting case for the module so that I can protect and secure the module?
I thought that the DSC Panels have pre-punched mounting holes where the supplied plastic standoffs just plug into and the Envisalink 3 secure to the standoffs. Are you looking for a separate standalone mounting case that completely enclose the ENL 3? I'm not sure what you are asking?
I have an Ademco 20P Panel and I had to drill the holes (3?) myself and then installed the standoffs.