EyezOn Forum

Hi,

I have my DSC PC1832 (v4.6) system programmed to require a code to arm it in order to prevent any "accidents." The web portal is only letting me arm it in "stay" mode. How do I get it to arm in "away" mode? Is there a magic "sequence" I can send it to arm in away mode?

Ok, to answer my own question, you need to:

1) Click "Arm" and then "Away Arm"
2) BEFORE the queue gets pushed, click "Commands", enter your code into the "Sequence" box, and click "Send"

After the delay expires the system will be armed in "away" mode even if you do not violate an entry/exit zone.