a few questions on TPI interface

[mrmin24]

Hi,

I am using the Envisalink 3 on my 1864 DSC.

I am able to get zone statuses and arm and disarm the system from my web application.

I have a few questions if anyone can maybe help:

#1 - I would like to be able to arm the system, but have a 0 exit delay (only when done with Envisalink)

#2 - I have managed to send a "*1" command when in stay mode and it then changes to "Away" which is actually "night/sleep" mode where it ignores the zones set up for it. There is however no indication from the panel that this is in fact the case, other than that it changes to away mode. Is there a way to get this state from the panel?

#3 - when I send a "**" command whilst in "Night" mode, the panel ignores the keystrokes, even though it acknowledges the command. There is thus no way to get out of night mode without disarming the panel?

#4 - when the keypad mode is set to switch off all the leds and backlight when not used, the status received from the envisalink is incorrect.

Sorry for the long post,

Any help will be appreciated.

Thanks