EyezOn Forum

From the evl3 Honeywell guide:

In order to receive alerts, you need to program your panel to send the alerts. All reports are optional so only enable the ones you want to see. Remember, you can always suppress reporting of reports on the alerting server so we recommend enabling all reports.

Go to the following sections and program them with 11, or keep hitting 1 until your hear three beeps from the keypad.
*59 - Exit Error Reporting
*60 - Trouble Reporting
*61 - Bypass Reporting
*62 - AC Loss Reporting
*63 - Low Battery Reporting
*65 - Openings (disarming) Report
*66 - Closings (arming) Report
*67 - RF Low Battery Reporting
*68 - Cancel (opening after alarm) Reporting
*70 - Alarm Restorals Reporting
*71 - Trouble Restorals Reporting
*72 - Bypass Restorals Reporting
*73 - AC Fail Restoral Reporting
*74 - Low-Bat Restoral Reporting
*75 - RF Low-Bat Restoral Reporting


But where can I disable these reports from the interface?

In your contact settings you can select which types of alerts you wish to receive.

Oh, so that is what it was referring to. They are not the same type of alerts however so I thought they were referring to something different or a different option somewhere in the system.

A some what related question.
On a Vista 20P I am using the built in dialer to call my alarm company and will be adding a Envista 3 also to help me monitor the alarm system.

I believe the answer is "no" but here goes any way: Can different alarm events be sent to the built in dialer and the Envista 3? Such as "AC power loss" to me and not the monitoring company?