Page 1 of 1
EnvisaLink-3 with Vista 20SE Panel
Posted: Fri Jan 23, 2015 10:19 am
by Craig
I know the EnvisaLink-3 can't send commands to an older Vista 20SE panel but I have read that it should be able to get alerts from the panel. Has anyone actually gotten this to work?
Re: EnvisaLink-3 with Vista 20SE Panel
Posted: Fri Jan 23, 2015 1:59 pm
by TD22057
I realize this isn't much help, but I could not. So I spent the $60 to get a 20P and swapped out the boards.
Re: EnvisaLink-3 with Vista 20SE Panel
Posted: Sat Feb 07, 2015 1:05 pm
by GRASONC
Hi All, new to this forum. Interested in EVL-3 to add to our system but believe we may have an older Vista20 SE flavor. Hard to tell exactly (at least by me) but hoping some of you more experienced folks can advise. The system is a Safewatch Pro that was installed by ADT in 1999. The main board has printing indicating SA20ADT. From other postings, it seems that this is likely a Vista 20SE system. Can someone confirm this or is there any other way I can verify exactly which version I have? Thanks in advance!
Re: EnvisaLink-3 with Vista 20SE Panel
Posted: Sun Feb 08, 2015 9:41 am
by GrandWizard
Post a picture of the panel.
Re: EnvisaLink-3 with Vista 20SE Panel
Posted: Sun Feb 08, 2015 2:13 pm
by GRASONC
Please see attached. Traveling so the wife took the photo but there is print at the top of the PCB stating SA20ADT.
Re: EnvisaLink-3 with Vista 20SE Panel
Posted: Sun Feb 08, 2015 2:20 pm
by GRASONC
Trying again. Not sure picture made it with the previous post.
Re: EnvisaLink-3 with Vista 20SE Panel
Posted: Sun Feb 08, 2015 10:47 pm
by GrandWizard
That is an SE panel. You can tell by the large black heatsink.