Page 1 of 1
New DSC1832
Posted: Tue May 19, 2015 12:14 pm
by mark2457
Hi Guys
Just came across Envisalink and will try on a new install in a few weeks.
Given the panel is brand new, how much programming do I have to before i can switch to portal?
Regards
mark
Re: New DSC1832
Posted: Tue May 19, 2015 6:44 pm
by GrandWizard
There is a no programming required for DSC panels.
Re: New DSC1832
Posted: Wed May 20, 2015 10:03 am
by mark2457
GrandWizard wrote:There is a no programming required for DSC panels.
So I unbox a DSC panel. Plug-in the envisalink board and go straight to the Eyezon web site setup all my zones, partitions, users, etc.?
Sounds great if that really is the case
Re: New DSC1832
Posted: Wed May 20, 2015 10:14 am
by GrandWizard
Maybe I misunderstood you. There is no programming required to install an Envisalink module on a DSC panel. You will need to program your security system for all your zones etc. like any normal installation.
Re: New DSC1832
Posted: Wed May 20, 2015 10:34 am
by mark2457
GrandWizard wrote:Maybe I misunderstood you. There is no programming required to install an Envisalink module on a DSC panel. You will need to program your security system for all your zones etc. like any normal installation.
OK thnaks