EyezOn Forum

Hello...loving my E3...just a quick simple question...When I am in the commands window..how do I bypass multiple zones...I can do it for one and then wait and ready for arming but can I do it for multiple zones on one command line?

Thanks..Steve.

Is your system a DSC? You can use zone 99 and it will recall the zones bypassed when it was last armed.

Also you can enter a command string if it's a DSC

Example :
To bypass zone 1, 5 and13
Enter *1010513#

Where:
*1 For bypass command
Followed by all the zones you want (2 digits)
Finish with a #

Hello...so from my phone I would enter that command string in the bypass and I should be good to go correct?

Thanks...Steve.

When I use the interface on the android...in the bypass field it does not accept * or # but the procedure that you mentioned works fine on the DSC keyboard.

You would enter that into the custom sequence field and not the bypass field.