EyezOn Forum

I have an EnvisaLink 3 successfully set up with my Vista 128 panel, and I am able to arm/disarm using the local and remote (eyez-on) web pages.

I'm also able to use linux to connect to the TPI, and log in successfully, and receive the following realtime data (as an example):

%01,04000000002C0000$
%00,01,0008,43,00,FAULT 043 300 MOTION DETECTOR $
%00,01,0C08,43,00,****DISARMED**** ZONES FAULTED $
%00,01,0008,03,00,FAULT 003 FRONT DOOR UNLOCKED $

If the system was in a state where it could be armed (I realize that my example shows a state when it cannot be armed), how would I send a command to arm the system?

Thanks for your help in advance!
-EP

I think I figured it out.

Where XXXX = 4 digit code:

XXXX2 {carriage return}

I'll do some testing this evening to be sure.


Thanks.
-EP