Vista 20 P and wireless motion zones

Information and support for EnvisaLink modules.

Moderators: EyezOnRich, GrandWizard

Post Reply
pattam
Posts: 1
Joined: Sat Oct 24, 2015 4:14 pm

Vista 20 P and wireless motion zones

Post by pattam »

I have a Vista 20p that I am running wireless. The door contact zones report an alarm when triggered. However, while in Away, while the motion detector does set the alarm off (in an instant), it does not seem to be reporting back up to the monitoring. I did use the same reporting code for all zones. I have them set up as interior follower type 04. Any ideas? Thanks in advance.

On the events it says ""Exit Fault" rather than an "alarm".
GrandWizard
Posts: 2375
Joined: Tue Nov 16, 2010 4:08 pm

Re: Vista 20 P and wireless motion zones

Post by GrandWizard »

Exit Fault is a type of false alarm. It means the alarm was tripped shortly after being armed (closed) and therefore is probably someone not closing the door properly. If a monitoring station receives and Exit Fault, they are usually ignored.

Try arming your system and waiting 5 minutes before you trip it.
Post Reply