Page 1 of 1
Programming a 20P through the Eyez-On Device
Posted: Thu Oct 29, 2015 9:54 pm
by Carter56
I recently visited my sister in VT - 6 hours from my home. Installed a 20P and an Eyez-On 3 Device. All worked well....and a week later a Honeywell wireless door transmitter needs to be replaced. I dread the long trip to install a new transmitter and reprogram the panel. Is there any way to program a specific zone on a 20P for a wireless device through the Eyez-On 3? If so - please provide me with the details.
Many Thanks!
Re: Programming a 20P through the Eyez-On Device
Posted: Fri Oct 30, 2015 12:03 am
by DeanRobinson
If you have an old 2400 baud Hayes modem laying around and her panel is hooked to a land line you could dial into the panel and make the changes using Honeywell compass software to make the changes, I can help you out if needed. "No Charge" I just do it as a hobby and to help people out.
Dean
Re: Programming a 20P through the Eyez-On Device
Posted: Mon Nov 02, 2015 8:23 am
by Carter56
Thanks Dean,
Unfortunately her 20P is not connected to a phone line.