Feel like an idiot... EVL-3

[dbecks]

So I moved into a house that had an EVL three and re-registered it to my account. I have access to it but am lost at how to program commands. When I pull up available commands it only shows PGM, Zone, Sequence and Send reset, no arm, no disarm. I am pretty lost and tried to figure it out. Am I missing something?

[Cobra]

Are you using the eyezon web interface to issue the commands?

[GrandWizard]

I would start with reading the manual for your panel first. Understand it's behaviour and then you will understand the Envisalink easier. You won't see an ARM command option if your partition isn't ready. This means that all zones have to be secured.