Envisalink 4

akito · Post by **akito** » Tue Dec 01, 2015 7:16 pm

Hi there, I just got the EVL4 and hooked it up to my DSC (vista 20p/honeywell chip on board) alarm panel.
I am able to get to the localwebsite no problem, and I have registered the device.

On the device the KEYB LED is blinking. According to the quickstart manual this means 'Panel not connected (DSC firmware installed)

I can't seem to find the documentation on what my next steps should be.

Can anyone point me in the correct direction?

Thanks!

edit: I did a full reset and started from scratch. the keyb light is now on solid. I am now seeing the settings on the onboard website for the device. I will continue setting up the device as per the honeywell vista setup page.
woot!