Thanks for any suggestions
Steve K
Fixed it!... Support suggested moving the keypad address. That worked. Not sure what was on address 19...maybe the old GSMX was still assigned to 19...anyway it works.
Problem with Envisalink 4 install arming system via Website
Moderators: EyezOnRich, GrandWizard
Problem with Envisalink 4 install arming system via Website
I just installed EnvisaLink 4 on my existing Vista 20p. Thought I followed all instructions. Website says system is ready and if I arm it locally it shows up armed on website so it is communicating. Problem is if I try to arm via website command is stuck in que and nothing happens locally. Is the user code the same code as my panel? All lights on Envisalink are green *29 is enabled. I removed a GSMX module and installed the Envisalink, so I have LRR shadowing off. What am I doing wrong?
Thanks for any suggestions
Steve K
Fixed it!... Support suggested moving the keypad address. That worked. Not sure what was on address 19...maybe the old GSMX was still assigned to 19...anyway it works.
Thanks for any suggestions
Steve K
Fixed it!... Support suggested moving the keypad address. That worked. Not sure what was on address 19...maybe the old GSMX was still assigned to 19...anyway it works.