EnvisaLink4
Arm the system. Wait. Trigger an entry. Wait for siren. Wait 30s dial delay.
No alarm reported. No email. No text message. CS reports nada.
However: What I do get, every time, is a double "opening by user <whomever>" at about the time I should think the alarm should've been reported.
I have received "Door <whatever>" alarms, but, apparently, only when the system was placed in "away" and I was testing all the zones, having put it into alarm by tripping an interior motion, first.
What am I missing?
Since then: Have tried changing the RC on one entry from "10" to "11": Same thing. Eliminated the dial delay. Same thing. Tried it arming the system for "AWAY," instead of "STAY": Same thing: Timer expires, alarm goes off, and nothing is reported until I deactivate the alarm, then a double "Opening by user..." report.
Something seems awry to me.
Update the 2nd: Reviewed the Honeywell Vista Setup. Occurred to me that, when that document says set all those registers to "11", then asserts "or keep hitting 1 until your hear three beeps", that latter suggestion is incorrect. If you really want to code decimal "11", hexadecimal "B", into those registers, you have to enter "#11" for each. (Which can mean up to nine times per "field": three times each for each of three partitions [1, 2 and common] for a 20P.)
Did that. Re-programmed all the others, too. No change. Thinking multiple errors: Also set the entry zone I'm testing back to an RC of "11".
Pas différence. No matter what I do: Alarming an entry results in no report and a double "opening by..."
