EyezOn Forum

I am preparing to install 2DS so I downloaded program and instructions. Instructions download link says it is based on version 1.0 but the actual document says it is based on version .80 and does not include information about Envisalink 2DS.

Most of config looks simple except one for Relay server with 2DS. Can you put me on right track so I get it right first time?

Thanks,
Jack

Plug it in (ethernet) and wire it to the Keybus as per the instructions. It will auto-configure itself as a DVAC communications device. Once you go to the portal and create the account with the device ESN, you should see it start to communicate with the panel. Providing the hardware is good - it's pretty much self-installing. You might want to power down during the wiring phase just to be safe.

You should install again