EyezOn Forum

The latest release of firmware for the Envisalink 3(Honeywell Users) is now being pushed out. The version is 1.08.102.

Before all the DSC people out there start calling and wondering why the latest version for Honeywell is 1.08.102 and DSC is just 1.08.101, its because they are different builds of firmware with different revisioning. They will probably allways be different.

Release Notes:
- Vista 21P support verified. Support is now for 10P, 15P, 20P, and 21P
- Partition 2 keypad address defaults to 0 (off)
- EnvisAlarms monitoring is now fully supported

This firmware unfortunately defaults your Partition 1 keypad address to 18 and your Partition 2 Keypad address to 0.

If you had it set to something else then you need to change this on your local Envisalink page.

Sorry for the inconvenience, it won't happen in future builds.