EVL 3 Change from Ademco to DSC

[microbizz]

I have a EVL3 and it was installed on a Vista 20, I just installed a DSC PC1832, now I can't get the board on line. The network lights flash, The keybus light never goes green. Cant find on network. I read that the firmware is Ademco now. I tried shorting s1 and so. Also could not register on EyesOn as it was already registered to MyConnect2go. Do i own a brick now ?

[GrandWizard]

I have a EVL3 and it was installed on a Vista 20, I just installed a DSC PC1832, now I can't get the board on line. The network lights flash, The keybus light never goes green. Cant find on network. I read that the firmware is Ademco now. I tried shorting s1 and so. Also could not register on EyesOn as it was already registered to MyConnect2go. Do i own a brick now ?

Well if the module is a Connect2Go module then you won't be able to use it with Eyezon. Contact support@eyezon.com and send in a picture of the module and we can confirm if it is a Connect2Go version. You can change the firmware back to DSC on an EVL3 but you need to first register it with Eyezon and select Envisalink 3 Honeywell as the panel type. The module will then switch firmware back to DSC within 10 minutes.