Page 1 of 1
New install can't Access the IP Address
Posted: Sun Oct 21, 2018 3:10 pm
by Ozyris
Good afternoon all,
I'm a new user just installed the EVL4 module to my honeywell vista 10SE. all lights are green but I'm getting a keypad address programming not completed error and a *29 error. The IP address 192.168.0.135 is not loading. I try disconnecting everything from the network, still not working. Need help accessing the local page. Thanks
Re: New install can't Access the IP Address
Posted: Sun Oct 21, 2018 5:20 pm
by GrandWizard
The Vista 10SE is not a supported panel, hence your errors.
Also, the 192.168.0.135 shown in the manual is an example, yours will be different.
Re: New install can't Access the IP Address
Posted: Mon Oct 22, 2018 8:15 pm
by Ozyris
?? When I purchased it, it stated 10P. I was able to to enter in the account, is it secured, the message displayed not secure. The directions also listed 10P installation steps?
Re: New install can't Access the IP Address
Posted: Mon Oct 22, 2018 8:24 pm
by GrandWizard
You said you had a Vista 10SE. Which is it?
Re: New install can't Access the IP Address
Posted: Mon Nov 12, 2018 2:26 am
by Ozyris
My apologies for the late reply. I just installed a new Vista 20P panel, still having error 29. Followed the manual instructions, no change, not sure what to do. I do not have a communicator at this time. I unchecked that step as instructed. Thanks for any help you can provide.
Re: New install can't Access the IP Address
Posted: Mon Nov 12, 2018 10:58 am
by GrandWizard
Ozyris wrote:My apologies for the late reply. I just installed a new Vista 20P panel, still having error 29. Followed the manual instructions, no change, not sure what to do. I do not have a communicator at this time. I unchecked that step as instructed. Thanks for any help you can provide.
Submit a tech support request from your Eyezon portal by going to the Request Support Link.
It sounds like you haven't enabled *29 as per the instructions on Page 9. On newer panels the sequence is: *29 1 * 0 * *