EVL3 and Honeywell Vista 21IP panel not talking
Posted: Sun Nov 04, 2012 6:31 pm
Support, I have followed all the "descructions" the best that i can. twice and even 4-5times. there must be a few steps missing from the instructions or the local setup on the module I have Installed thse on DSC panels and it's a piece of cake but when it comes to Honeywell panels, not so much.
I tried your forums, other forums, you tube.. and the web, and it looks like i can't find any help to make your EVL-3 communicate with my Vista 21-IP panel
EVL-3 Mac address: 001C2A00XXXX firmware version 01.08.101. The EVL-3 is activated.
The Vista panel is a Vista 21-IP with on-board ethernet port but a non-installed GSM. I do not have it activated with TotalConnect. I have tried with the onboard ethernet jumper removed and shorted. Rebooted the panel, the router.
The red light is blinking on and off but the green KEYB is not on.. and according to the local programming when I connect to the module with the browser locally with ID:user/PW:user it tells me it's connected to a DSC system.
Any help would be appreciated
I tried your forums, other forums, you tube.. and the web, and it looks like i can't find any help to make your EVL-3 communicate with my Vista 21-IP panel
EVL-3 Mac address: 001C2A00XXXX firmware version 01.08.101. The EVL-3 is activated.
The Vista panel is a Vista 21-IP with on-board ethernet port but a non-installed GSM. I do not have it activated with TotalConnect. I have tried with the onboard ethernet jumper removed and shorted. Rebooted the panel, the router.
The red light is blinking on and off but the green KEYB is not on.. and according to the local programming when I connect to the module with the browser locally with ID:user/PW:user it tells me it's connected to a DSC system.
Any help would be appreciated