EyezOn Forum

Hi, been wanting to try creating partitions for some time now and finally got around to it. I created 3x partitions, Partition 1 - All Exterior and Interior Beams/ PIR's, Partition 2 - Exterior Beams only and Partition 3 for Interior PIR's.

As for as I can see, I've enabled the partitions under section [201] and the individual zones are selected under the partition zone assignment [202] to [221], done as follows:
The issue I have for Partition 2 (Exterior) & 3 (Interior) is that it does not show the zones and something I picked up is that even if a zone is opened, I can still activate arming in Partition 1(Exterior & Interior). For now I've just disabled Partition 2 & 3, until I can get some help to figure out what I've missed?....

In case anyone else runs into this thinking their partitions are not getting detected by Envisalink, just be sure to log in to the web portal and name your devices + assign them to the correct zone (Manage Device -> Zone Labels). You should see them in the correct place in the mobile app afterwards.